Antena Channel Master 1.8m Offset Tx/Rx Type 183

This manual covers the installation of the Channel Master 1.8m SMC antenna system with AZ/EL cap mount and Ku-single polarity feed.

For best results in the assembly process, perform each step in the same sequence as listed in this manual.

Download Hoja de Datos en PDF

Antena ASC Signal 1.8 m C-band Circular Polarized Type 183

The ASC Signal 183 1.8 m Class III RxTx Antenna is a rugged commercial grade product suitable for the most demanding applications. The reflector is thermoset-molded for strength and surface accuracy. Molded into the rear of the reflector is a network of support ribs which not only strengthens the antenna, but also helps to sustain the critical parabolic
shape necessary for transmit performance.

The Az/El mount is constructed from heavy-gauge steel to provide a rigid support to the reflector and feed support arm. Heavy-duty lockdown bolts secure the mount to any 114 mm (4.50”) O.D. mast and prevent slippage in high winds. Hot-dip galvanizing is standard on this model for maximum environmental protection.

  • All materials comply with EU directive No. 2002/95/EC (RoHS).
  • One-piece precision offset thermosetmolded reflector.
  • Heavy-duty galvanized Az/El mount.
  • Fine Azimuth and elevation adjustments.
  • Galvanized support arm and alignment struts.
  • Factory pre-assembled mount.
  • Galvanized and stainless hardware for maximum corrosion resistance.
  • RF tested feed assembly.
  • Heavy-duty Class III mount for 11 kg (25 lb) RF electronics (LNB & BUC).

Download Hoja de Datos en PDF

Antena ASC Signal 1.8 m C-band Linear RxTx Class III Type 183

The ASC Signal Type 183 1.8 m Class III RxTx Antenna is a rugged commercial grade product suitable for the most demanding applications. The reflector is thermoset-molded for strength and surface accuracy. Molded into the rear of each reflector is a network of
support ribs which not only strengthens the antenna, but also helps to sustain the critical
parabolic shape necessary for transmit performance.

The Az/El mount is constructed from heavy-gauge steel to provide a rigid support to the reflector and feed support arm. Heavy-duty lockdown bolts secure the mount to any 114 mm (4.50”) O.D. mast and prevent slippage in high winds.

Hot-dip galvanizing is standard on this model for maximum environmental protection.

  • All materials comply with EU directive No. 2002/95/EC (RoHS).
  • One-piece precision offset thermosetmolded reflector.
  • Heavy-duty galvanized Az/El mount.
  • Fine Azimuth and elevation adjustments.
  • Galvanized support arm and alignment struts.
  • Factory pre-assembled mount.
  • Galvanized and stainless hardware for maximum corrosion resistance.
  • RF tested feed assembly.
  • Heavy-duty Class III mount for 11 kg (25 lb) RF electronics (LNB & BUC).

Download Hoja de Datos en PDF